I install the QuickStart on my AWS server but all I get is a blank page. I have downloaded a couple templates and get the same thing. I am almost positive it is either a server setting or I don't have the correct settings for mysql or php. When I put the website in offline mode. I can see the page.
Any help would be appreciated. I can give the IP address upon request.
After Installation of Quickstart...blank page
Rate this topic: 
1.00 out of 6 based on 1 vote(s)
1.00 out of 6 based on 1 vote(s)- GK User
- Wed Jul 16, 2014 6:28 am
- Reply with quote
- Report this post
You can set error reporting in Joomla admin panel (Error Reporting -> Maximum in Server tab) - this should allow you to check what is the error.
-
- Moderator
- GK User
- Wed Jul 16, 2014 2:36 pm
- Reply with quote
- Report this post
Cyberek,
So I figured out what the issue was, it was a module that wasn't working. I'm still doing research into it and I'll be sure to post my results.
Thanks for the response!
So I figured out what the issue was, it was a module that wasn't working. I'm still doing research into it and I'll be sure to post my results.
Thanks for the response!
-
- Fresh Boarder
- GK User
- Thu Jul 17, 2014 9:25 am
- Reply with quote
- Report this post
NSP is very settings sensitive. If you will point it's data source to not existing data - then the problem will happen.
-
- Moderator
4 posts
• Page 1 of 1